How to insulate the walls and waterproof them

The low degree of insulation in a house builds up to 50 percent of the expense of heating and cooling. Assuming there is insulation in your home and condensation happens, it very well may be insulated from within. On the off chance that a reform is made, there are insulation solutions outwardly. (εποξειδικα δαπεδα)

Glass fleece or mineral fleece is an optimal material for thermal insulation. It is covered with plasterboard plates that constitute the interior coating. These plates might be standard or waterproof. Beneath we will let you know the bit by bit that you should follow to insulate the interior walls and waterproof them .

The most effective method to lay thermal insulation in the interior

1.1. Marked

Place the ruler and soul level and draw the main reference blemish on the ground.

Measure the thickness and interpret it from the primary reference mark.

Then, place a piece of plasterboard to make the last reference mark that will act as a base to fix the channel.

Rehash similar interaction for the other casings.

At long last imprint the reference point with the tracer to make the installation.

1.2. rooftop checking

Place the ruler and soul level upward over the reference blemish on the floor to extend it onto the ceiling. Rehash the operation at the flip side.

Mark the reference line on the ceiling with the scriber.

1.3. Fix the profiles on the wall

Fix the horizontal profile at half level of the wall (or at a greatest level of 135 cm on the off chance that the ceilings are high).

Do it so the trimmings are situated at the joints assuming the wall is made of empty materials and fix the profile at standard timespans cm with nailing plugs.

1.4. On the floor (εποξειδικα δαπεδα)

Stick the tough tape under the channels that will go on the floor and on the ceiling.

Then, put the channels on the reference marks.

Drill each 50 cm with the assistance of the drill, place the dowels and nail them.

1.5. In the rooftop

Rehash a similar cycle on the ceiling, joining the channels with drywall screws.

Fix the fixing clasps and dowels at ordinary time frames centimeters with nailing plugs.

On the off chance that there is a window, begin 10 cm from the edge.

Lay the glass fleece

Step 2.1.

Measure the level of the surface you need to insulate from the floor to the ceiling and add 2 centimeters.

Place the glass fleece sheet recently sliced according to the previous estimation, ensuring that it is all around nailed in the fixing clasps and dowels and that it is very much connected behind the channels.

Step 2.2.

Measure the range from the floor to the ceiling.

Moves that estimation to the profile.

Slice the profile to the suitable size and spot it in the channels.

Place the clasp and the fixing spike on the profile and with the assistance of a ruler change and lock it. https://seo1.gr/

Step 2.3. around the window

.Measure the distance between the two profiles on each side of the window and cut another with this equivalent estimation.

.Place the union clasps and fit the rail.

.Once fitted, screw it into the window outline by putting a piece of plasterboard to get the legitimate distance.

.Measure the distance between the floor and the window and add 2 cm.

.Mark this estimation on the glass fleece sheet and cut it out before placing it.

.Rehash a similar interaction to finish the insulation under the window.

.At last, tape the joints between the glass fleece sheets to streamline the nature of the insulation.

.Place the fixing clasps and dowels and spot the profiles continuously leaving a time period of centimeters and lock them.

.Rehash a similar cycle for the insulation at the highest point of the window to finish off the edge. Continue with the remainder of the wall. next blog